-- *****************************************************************
-- CISCO-DS0BUNDLE-EXT-MIB
--
-- July 1998, Vasmi Abidi
--
-- Copyright (c) 1998 by cisco Systems, Inc.
-- All rights reserved.
-- *****************************************************************
--
-- This mib extends CISCO-DS0BUNDLE-MIBCISCO-DS0BUNDLE-EXT-MIB DEFINITIONS::=BEGINIMPORTSMODULE-IDENTITY,OBJECT-TYPEFROM SNMPv2-SMI
MODULE-COMPLIANCE,OBJECT-GROUPFROM SNMPv2-CONF
TEXTUAL-CONVENTIONFROM SNMPv2-TC
ciscoExperiment FROM CISCO-SMI
InterfaceIndex, ifIndex FROM IF-MIB
dsx0BundleEntry FROM CISCO-DS0BUNDLE-MIB;ciscoDs0BundleExtMIB MODULE-IDENTITYLAST-UPDATED"9806300000Z"ORGANIZATION"Cisco Systems"CONTACT-INFO"
Cisco Systems, Inc.
170 West Tasman Drive,
San Jose CA 95134-1706.
Phone: +1 408 526 5260
Email: cs-snmp@cisco.com"DESCRIPTION"The MIB module for managing DS0 Bundles.
This MIB contains additional objects to supplement the
the IETF draft ds0Bundle MIB."::={ ciscoExperiment 33}ciscoDs0BundleExtMIBObjects OBJECTIDENTIFIER::={ciscoDs0BundleExtMIB 1}
cdsx0BundleConfig OBJECTIDENTIFIER::={ ciscoDs0BundleExtMIBObjects 1}cdsx0BundleInfo OBJECTIDENTIFIER::={ ciscoDs0BundleExtMIBObjects 2}-- Textual ConventionsDs0ChannelList ::=TEXTUAL-CONVENTIONSTATUScurrentDESCRIPTION"A list of ds0 timeslots on a DS1 line.
The list is specified as an OCTET STRING in which each ds0
timeslot is represented by a single bit, where timeslots 1
through 8 are represented by the bits in the first octet,
timeslots 9 through 16 by the bits in the second octet,
etc. In each octet, the lowest numbered timeslot is
represented by the most significant bit, and the highest
numbered timeslot by the least significant bit. A timeslot
is present in the list when its bit is set, and absent
when its bit is reset.
If the OCTET STRING value has fewer bits than required to
represent one or more timeslots on a DS1, then those
timeslots are absent from the list. If the OCTET STRING
value has more bits than required to represent the
timeslots on a DS1, then the extra bits are ignored. "SYNTAXOCTETSTRING(SIZE(0..4))--cdsx0BundleExtTable OBJECT-TYPESYNTAXSEQUENCEOF Cdsx0BundleExtEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"This table is used to supplement the
dsx0BundleTable."::={ cdsx0BundleConfig 1}cdsx0BundleExtEntry OBJECT-TYPESYNTAX Cdsx0BundleExtEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"Contains objects to configure a ds0Bundle.
The values of objects cdsx0BundleExtDs1Index and
cdsx0BundleExtChannelMap must be specified for
the associated row to become active."AUGMENTS{ dsx0BundleEntry }::={ cdsx0BundleExtTable 1}
Cdsx0BundleExtEntry ::=SEQUENCE{
cdsx0BundleExtDs1Index InterfaceIndex,
cdsx0BundleExtChannelMap Ds0ChannelList,
cdsx0BundleExtEncapType INTEGER,
cdsx0BundleExtChannelRate INTEGER}cdsx0BundleExtDs1Index OBJECT-TYPESYNTAXInterfaceIndexMAX-ACCESSread-writeSTATUScurrentDESCRIPTION"The ifIndex of the DS1 line containing the ds0
timeslots in this bundle.
The ds0 bundle interface is layered on top of
the DS1 line. This layering is represented in
the ifStackTable.
This object is not instantiated until the value
is specified.
The value may be set only when the ds0 bundle
is created."::={ cdsx0BundleExtEntry 1}cdsx0BundleExtChannelMap OBJECT-TYPESYNTAX Ds0ChannelList
MAX-ACCESSread-writeSTATUScurrentDESCRIPTION"A list of ds0 timeslots that comprise this ds0
bundle.
This object is not instantiated until the value
is specified.
The value may be set only when the ds0 bundle is
created."::={ cdsx0BundleExtEntry 2}cdsx0BundleExtEncapType OBJECT-TYPESYNTAXINTEGER{none(1),atmFuni(2),
frameRelay(3)}MAX-ACCESSread-writeSTATUScurrentDESCRIPTION"The type of encapsulation for this bundle.
A ds0 bundle is a logical serial port.
Setting this object defines the type of the serial
port.
If not specified, the value is none(1),
indicating that the encapsulation type on this
serial port is not defined.
If the value is changed to atmFuni(2), the
agent will create an entry in the ifTable with
ifType equal to atmFuni(106). If the value is
changed to frameRelay(3), the agent will create
an entry in the ifTable with ifType equal to
frameRelayService(44).
The new atmFuni or frameRelayService interface
is layered on top of the ds0 bundle interface.
This layering will be represented in the
ifStackTable.
The value of this object can be changed only if
the ifOperStatus of the associated atmFuni or
frameRelayService interface is down.
When the value is changed, the agent removes
all existing connections on the interface, and
also deletes the ifEntry that was created
because of the previous value."::={ cdsx0BundleExtEntry 3}cdsx0BundleExtChannelRate OBJECT-TYPESYNTAXINTEGER{rate56(1),rate64(2)
}MAX-ACCESSread-writeSTATUScurrentDESCRIPTION"The data rate of each ds0 in this bundle.
rate56 - 56kb/s
rate64 - 64kb/s
For ds0's on a T1 line, the value should be
rate56(1) if 'robbed bit' signaling is used,
and rate64(2) if clear channel signaling is
used.
For ds0's on a E1 line, the value should always
be rate64(2).
The value can be set only when the entry is
created."DEFVAL{ rate64 }::={ cdsx0BundleExtEntry 4}--cdsx0BundleUseTable OBJECT-TYPESYNTAXSEQUENCEOF Cdsx0BundleUseEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"Shows the ds0 timeslots that are currently in
use (i.e., part of a ds0 bundle) on
channelized DS1 lines.
There is an entry in this table for each
channelized DS1 line which has an ifEntry."::={ cdsx0BundleInfo 1}cdsx0BundleUseEntry OBJECT-TYPESYNTAX Cdsx0BundleUseEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"Contains the ds0 timeslots that are currently
part of various ds0 bundles on the DS1 line
identified by the ifIndex.
This information can be useful for an NMS when
creating new ds0 bundles on this DS1."INDEX{ ifIndex }::={ cdsx0BundleUseTable 1}
Cdsx0BundleUseEntry ::=SEQUENCE{
cdsx0BundleUseDs0Used Ds0ChannelList
}cdsx0BundleUseDs0Used OBJECT-TYPESYNTAX Ds0ChannelList
MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"A list of ds0 timeslots on this DS1 line that
are currently in use, i.e., are part of some ds0
bundle."::={ cdsx0BundleUseEntry 1}-- ConformanceciscoDs0BundleExtMIBConformance OBJECTIDENTIFIER::={ ciscoDs0BundleExtMIB 3}ciscoDs0BundleExtMIBCompliances OBJECTIDENTIFIER::={ ciscoDs0BundleExtMIBConformance 1}ciscoDs0BundleExtMIBGroups OBJECTIDENTIFIER::={ ciscoDs0BundleExtMIBConformance 2}ciscoDs0BundleExtMIBCompliance MODULE-COMPLIANCESTATUScurrentDESCRIPTION"The compliance statement for DS0Bundle interfaces."MODULE-- this moduleMANDATORY-GROUPS{ ciscoDs0BundleExtConfigGroup,
ciscoDs0BundleExtInfoGroup }::={ ciscoDs0BundleExtMIBCompliances 1}-- Units of ConformanceciscoDs0BundleExtConfigGroup OBJECT-GROUPOBJECTS{ cdsx0BundleExtDs1Index,
cdsx0BundleExtChannelMap,
cdsx0BundleExtEncapType,
cdsx0BundleExtChannelRate }STATUScurrentDESCRIPTION"A collection of objects providing the ability to
configure a ds0 bundle."::={ ciscoDs0BundleExtMIBGroups 1}ciscoDs0BundleExtInfoGroup OBJECT-GROUPOBJECTS{ cdsx0BundleUseDs0Used }
STATUScurrentDESCRIPTION"A collection of objects providing information
about which ds0 timeslots are in ds0 bundles."::={ ciscoDs0BundleExtMIBGroups 2}END